Injection Molded Plastic Cable Duct
Every industry needs solid and secure cabling and duct system to lay their power, signaling, and telecom lines. Ducting here refers to most effectively enclosing cables inside a custom-made plastic box. Be it underground or above the ground, the cables should not be laid directly without any protective covering. This is because exposed cables are susceptible to rodent attack, damages from nearby heat sources, and other external factors. Damage-proof cables or insulations are yet to be developed, so we need to consider safety measures to protect them and further ensure smooth power and signal transmission. The dangers of bare wire are many but finding fault is a tedious process in the case of cable laying in conventional RCC ducts, so we are up with a better alternative. The traditional process of cable ducting utilized RCC ducts, concrete trays, full round plastic or GI Pipes, etc. had drawbacks and did not meet the basic requirements. There is extensive use of RCC ducting in railway tracks, Airport, substations, metros and tunnel for laying cables, So they may be effectively replaced with injection moulded plastic cable duct.
JMV proposes installing an injection molded plastic cable conduit for easy and hassle-free cable laying. They are well-versed in anti-rodent and UV-resistant qualities, allowing them to be simply installed both below and above ground. They have a minimum breaking load of 12kN and a minimum breakdown voltage of 48kV. As a result, these must be placed for both S&T and power connections. The reason for the development of such cable duct is because it is recommended to use standard type ducting and properly install the cables in the ducts to ensure the safety of cables and the kind of supply that passes through these cables.
This remarkable advancement in technology for safety dealing of the cables are manufactured using special polymers are called polyolefin that is chemically inert. The process of manufacturing cable ducts is injection molding which gives better dimensional stability.
Polyolefin injection moulded plastic cable duct is ideal for laying any type of cable. No special technique or provision is needed; It has a Key and slot type joint for stable duct connection and disconnection. Power, signaling, and telecom are critical parts of every industry. They stay up only if the cables are maintained properly so they must be layed inside an effective ducting system with high mechanical strength. Here we speak of injection moulded cable ducts that are a maintenance-free solution and can withstand many compressive loads up to 12kN. Regarding the advantages of its weightless attribute, it is very easy to – check and correct faults, replace, transport, store, etc. All these tasks would require very little labor. They have a unique honeycomb design, which makes the entire product strong and better dimensional stability to handle heavy loads and external influences.
When cables are to be laid, protective covering is a must to rule out the main threats – moisture infiltration, rodent damages, environmental effects, load conditions, etc. for which plastic cable ducts are generally recommended as per standards to engineering a clean and proper cable management system even without much worker's expertise or large machinery. This is our engineer's choice as it needs no special machinery and manpower to save more in the process of installation, repair, replacement, relocation, transport, etc. Plastic ducts are the only best alternative when it comes to improving physical appearance. Moreover, they enable – easy inspection and faster troubleshooting while reducing the risk of human error as well. Just ensure that you procure it from a reliable manufacturer to make certain that you get the best quality product.
